(2) Sheet Cutters FUJAMAKI face width 2.550 mm

General information:

Simplex sheet cutter synchro FUJIMAKI 2550F-SOLG-2R
Material to be sheeted : White board
Basis weight : Min 300 – max 550 gsm (400 gsm as main range)
Roll width : Min 1600 – max 2600 mm
Roll diameter : Min 650 – max 2700 mm
Roll weight : Max 15000 kg
Roll unwind direction : Under-through
Roll center core : Reel-spool diameter 470mm
Crosscutter face width : 2550 mm
Finished width : Max 2450 mm (max width of total slit-out)
Min 450mm (min width of single slit-out)
Crosscut length : Min 500 – max 1400 mm
Designed speed : Max 350 m/min
Accuracy : Length, within +/– 0.5 mm
Width, within +/– 0.2 mm
Squareness, within +/– 0.5 mm ( at 1000mm)
Knife capacity : Max 600 gsm
Slitters : 5 slitters (1 set for spare) 3 outs
Sheet pile height : Max 1650 mm, palette height (approx. 150 mm)
Drive power side : Left side, seen from layboy
Pallet discharge side : Back side, taken by forklift
Power supply : AC 415 V 50 HZ 3 P for drive
AC 220 V 50 HZ 2 P for control
Pneumatic supply : 0.6 MPa (1.5Nm3/mim)

Duplex sheet cutter synchro FUJIMAKI 2550F-DOLG-2R
Material to be sheeted : White board
Basis weight : Min 300 – max 550 gsm (400 gsm as main range)
Roll width : Min 1600 – max 2600 mm
Roll diameter : Min 650 – max 2700 mm
Roll weight : Max 15000 kg
Roll unwind direction : Under-through
Roll center core : Reel-spool diameter 470mm
Crosscutter face width : #1 crosscutter 2000 mm
#2 crosscutter 1200 mm
Finished width : Max 2450 mm (max width of total slit-out)
Min 450mm (min width of single slit-out)
Crosscut length : Min 500 – max 1400 mm
Designed speed : Max 300 m/min
Accuracy : Length, within +/– 0.5 mm
Width, within +/– 0.2 mm
Squareness, within +/– 0.5 mm ( at 1000mm)
Knife capacity : Max 600 gsm
Slitters : 5 slitters (1 set for spare) 3 outs
Sheet pile height : Max 1650 mm, palette height (approx 150 mm)
Drive power side : Right side, seen from layboy
Pallet discharge side : Back side, taken by forklift
Power supply : AC 415 V 50 HZ 3 P for drive
AC 220 V 50 HZ 2 P for control
Pneumatic supply : 0.6 MPa (1.5Nm3/mim)